18" of 1�12" fir lumber "board"
4 two-inch casters (100 lb. load or greater)
16 - 3/4 inch wood screws
Let's make it
When doing this project be safe; read and follow the safety guidelines in your power tool manuals, measure twice, cut once, etc.
Sand board smooth. Screw a caster to each corner of the underside of the board about two inches in from the edge. Half way along each of the four sides of the board, drill a hole about one inch from the edge. Tie a pull rope through the front or back holes, and seat belts ropes through the side holes.